etc as a effects pedal and use amplitube as the amp modeler. Then once you have Amplitube working well through your RP355 you can start adding FXs, delay, reverb.
Set your buffer size to a to 5.6ms or 10ms this reduces the delay.ĥ.- On the RP355 make a new profile or edit an existing one and turn off the amplifier, to start I would turn off all the other effects so when you play you will only hear amplitube's sound through your pedal. The USB X-Edit software even allows you to adjust your sounds in a.
(make sure your rp355 software & drivers are installed)ģ.- On the pedal GO to "pickup" and on the AMP GAIN knob turn that clockwise all the way to RP 0 (this lets you hear only the usb amp modeling not the pedal's amp modeling)Ĥ.- Open amplitube 2/3 and on the settings setup set the input device (RP355 ASIO, and setup everything with RP355 input and output channels. Buy your Digitech RP355 guitar effect processor with USB at Bax Music and enjoy. This puts it in a pretty good position for the average guitarist, striking a good balance between size, hands-free capability, portability. This is how you have rp355 just as an interface where it can interact with amplitube without mixing up your sound but at the same time add your effects.ġ.- Make sure your rp355 software & drivers are installed.Ģ.-Connect your rp355 via usb to your computer, and connect your 1/4 or 1/8 to your amp or speakers. The RP355 is the mid-sized multi-effects unit from Digitech’s RP series, packing more pedals than the RP255 or 155, but not being quite as formidable and well-stocked as the larger RP500 or RP1000.